Re: Power Window regulator slipping

[Kneale Brownson <knotnook@traverse.com>]

If you find your doors are different from the Bentley you have, Colin, then
check out:

     http://www.ohlemacher.com/German%20Cars/audi/door_handle_removal.htm

That's for '91's, but it's hard to imagine there'd be a bunch of difference
between the '88 and '89, and then again between the '89 and '91.

Oh, I forgot, this IS Audi, isn't it?   <g>

Kneale Brownson


At 08:21 PM 11/18/99 -0400, Colin Barfoot wrote:
>Qlist,
>
>On my 1989 200 quattro.
>The drivers side front power window regulator is slipping such that the
>motor turns a while before the window starts to go down/up and finishes
>about 4 inches above the sill and on the up direction it finishes about 1/2
>inch below closed.  I can move the window down/up to complete the
>open/closing action but this doesn't produce a seal when closed (and raises
>security issues as well!).
>
>questions:
>1.  What is te correct sequenceforremovingthe door panel on this car?
>(I have the Bentley for the 85-88 5000 series- is there a similar reference
>that I can use.)
>
>2. Can I take apart the regulator and replace a clip or cable fastener
>somewhere? I have a regulator withabad motor from the rear window (passenger
>side ? I forget) could I use the mechanism - or parts of it with the
>existing working motor somehow?
>
>
>Thanks in advance for your assistance.
>Regards,
>Colin Barfoot
>
>