flywheel resurfacing?

[cobram at juno.com]

There is no way to machine a flywheel with these pins installed.   Since
you know you're going to machine it, buy the reference pins ahead of
time, and hand them to the machine shop and tell them these are in case
you have to destroy the old ones to remove them.  Sometimes they get
REALLY stuck, so use a machine shop with a good reputation, otherwise the
flywheel might get damaged during pin removal.  

BCNU,
Cobram at Juno.Com
http://www.geocities.com/MotorCity/Flats/1469/

 james accordino <ssgacc at yahoo.com> writes:
> Does anyone know what technique is used to resurface a
> flywheel with the reference pins?  Car is an 89 200q. 
> I remember reading a thread where someone tried to
> remove them with bad results.  Somebody must have had
> a flywheel resurfaced during a clutch replacement.


________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.