torque specs for 4kq exhaust manifold
Tom B
dr_hydro at hotmail.com
Thu Jun 7 13:32:46 EDT 2001
Russ,
Thanks for the tip, I ended up using the 4 cyl torque specs with no problem.
I had a very empty looking engine bay after removing the old head and
everything else that goes with it, now that the new head is installed it is
slowly filling back up as I put parts back on...... Now where did I put that
shoehorn? :-)
have a good one all,
Tom B.
'87 4kq- was beheaded, is now in the process of re-animation
<Tom,
<I went with the torque spec the Bentley lists for the 4-<cyl engine, 23nm
or
<17 lb-ft. I later found a Phil Payne post listing the <turbo "exhaust
joint"
<spec at 25 nm, so 23 sounded pretty correct for an NA <engine.
The EM studs on my car backed out quite easily, BTW. But they had been
replaced 50000 miles earlier. :-)
Russ Maki
Ixonia, Wis.
>From: "Tom B" <dr_hydro at hotmail.com>
>To: quattro at audifans.com
>Subject: torque specs for 4kq exhaust manifold
>Date: Wed, 06 Jun 2001 11:55:51 -0000
>
>Hello all,
>Once again I am having problems finding torque specs in the Bentley
manual.
>I am installing my exhaust manifold and cannot find the torque specs for
the
>em bolts in the bentley. I can find specs for any other bolt in the
exhaust
>system, just not those :-(. Help!!
>
>TIA,
>Tom B.
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
More information about the quattro
mailing list