still no spark

[Todd Phenneger]

I run an MC-1 Flywheel on my Kh and it runs great.  I tried an
ur-q flywheel and the car ran fine but the timing was off and
the car fell flat on its face at about 5k RPM.  Much better
witht he MC Flywheel.  So, if this flywheel worked on the KH, it
should work fine on the MC.
l8r
  Todd

--- luke <maytagasm at sympatico.ca> wrote:
> ok...
> is the PIN the same on the KH to late MC?
> that is the question...
> i know it was sent to a machine shop to have
> material removed, pin installed and balanced...
> so shouldnt it be right?
>
> luke
> 90tq
>
> >
> > --- luke <maytagasm at sympatico.ca> wrote:
> > > ok going to redo this manually...
> > > im going to remove the timing belt and spin the cam
> > > around and
> > > put the belt back on manualy as Javad advised... so
> > > they are
> > > ALL lined up...
> > > i see to remember the TDC pin on the flywheel NOT
> > > being under
> > > the sensor when the flywheel was at 0 degrees... im
> > > going to check...
> > > if its not... well... it ran on the KH....
> > > if somehow its not and cyl 1 is at TDC can i pretend
> > > the flywheel is at
> > > 0 there?
> >
> >
> > OK everyone, are we running into the problem I was
> > looking at when I wanted to add the timing pin to my
> > flywheel?  I wonder if the had a different config?
> >
> > Here is part of a post I saved.
> >
> > http://www.audifans.com/archives/1997/07/msg01029.html
> >
> > Looks pretty good to me, What do you think Brian?
> >
> >
> > 62btdt might be a good number, assuming you use the
> > correct 0 degree
> > mark,
> > which is not zero on your NG flywheel.  It is 6
> > degrees off on a MC.
> > You
> > could just scale around the perimeter 62 degrees, and
> > drill your hole
> > the
> > correct distance from the edges of the flywheel teeth.
> >  You need to
> > remove
> > material to clear the pin, and if the distributor is
> > not within 2
> > degrees
> > of the correct location, the car will not start.  Here
> > are some
> > examples of
> > the pin location removing the minimum amount of
> > material.
> >
> >
>
http://www.teenaflanner.com/chris/90tq_turbo_conversion_gallery/imagepages/f
> lywheel_correct_pin1.html
> >
>
http://www.teenaflanner.com/chris/90tq_turbo_conversion_gallery/imagepages/f
> lywheel_mod2.html
> >
> > =====
> > Jim Green
> > '89 90tq 034EFI Stage II
> > http://www.geocities.com/jeg1976/car_home.html
> >
> > __________________________________
> > Do you Yahoo!?
> > Yahoo! SiteBuilder - Free, easy-to-use web site design
> software
> > http://sitebuilder.yahoo.com
> >
>


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com