checking hall sender...

[JShadzi at aol.com]

--
[ Picked text/plain from multipart/alternative ]
Hehe...sorry Luke, you make me chuckle...the hall sender's electrical
connections are the 3-wired plug on the side of the distributor.  You should have 12v
between the 2 outside pins, and as the window passes through the hall window
you should see a 12v pulse from the center pin.  If you don't, you're Hall
isn't working properly.

HTH,
Javad

In a message dated 8/2/2003 1:12:13 PM Pacific Standard Time,
maytagasm at sympatico.ca writes:

> <snip>
> -test voltage in wire going to hall sender
> if ok...
> -plug hall sender wire back  in
> -spin crank till hall sender is not in front of window.
> -check voltage.
> <snip>
>
> where the @#$%#! do i check the voltage?
> the hall sender is plastic right? it sure looks it...
> i tried reading from various spots inside the dist...
> and grounding the black wire on the multimeter...
> where is it supposed to have voltage??!?!?!?!
>
> thanks everyone
>
> luke
> 90tq