UrQ MC conversion questions

[luke]

This is a multi-part message in MIME format.
--
[ Picked text/plain from multipart/alternative ]
>1)  Has anybody made a template to help cut the notch
>in the bell housing for the crank sensor?

check in http://www.newtsplace.com/90tq
goto the f.a.q.

>2)  What oil temp switches do I need to use?  I have
>the MC ECU (red) harness in place, but the UrQ chassis
>(yellow) harness.  The UrQ has a two-pin oil pressure
>sensor on the back of the head, but the MC has two
>single pin sensors on the block (idle & running low
>pressure).  The MC head seems to have two blanking
>plugs in the head holes where the WX has its sensors.
 >Do I stick the WX sensors into the MC head, or wire
>the MC units in the block?

id do whatever is easier... id try to using matching sensors to wires
ie. mc sensors with red harness...
not too sure though...
im pretty sure my car uses NG wires with MC sensors though...

>3)  How do I hook up the new fuel pump relay & wire it
>tp a "Check Engine" light?

not sure... i think its on
http://www.digitalnoise.org/4ktq/
if not thats a great site to read before your swap...
TONS of valuable info....

luke
Mc90tq
--