just to check some prices

[Christo Atanasov]

This is a multi-part message in MIME format.
--
[ Picked text/plain from multipart/alternative ]
10x a lot Javad ;)
my engine is HY, which is 2.2 NA engine with CR 10:1 so it's fine with NG p=
istons :))
$115 for a set + $50 for a set of rings is much better than $145 each :)
another question.. I can't find workshop that can make cylinder head to tak=
e 40mm intake vlve instead my 38mm intake - is it so dificult or they refus=
e as they underrstend that I wont this for 18 years old car?

regards,
Christo
  ----- Original Message -----
  From: JShadzi at aol.com
  To: chris at maimex.bg ; pcole at mn.rr.com
  Cc: quattro at audifans.com
  Sent: Wednesday, August 06, 2003 4:49 PM
  Subject: Re: just to check some prices


  The NG uses a 20mm wrist pin as does the JT and other NA 2.2's, the turbo=
 rods are beefier at 22mm and are not compatible with the NG pistons as the=
 MC uses a shorter rod as well, 136 vs 144mm for NA and 20v.

  Javad

  In a message dated 8/6/2003 1:09:35 AM Pacific Standard Time, chris at maime=
x=2Ebg writes:


    10x Paul,
    Yesterday I found a set of used NG pistons for about $115.
    Can some confirm that diametar of NG wrist pin is identical to diameter=
 of
    wrist pin of my 2.2, so I can use my old set of connection rods and pin=
s=2E
    Is this conclusion true - if my engine is 10:1CR, and NG is 10:1 so dis=
tance
    between center of wrist pin hole and top of the piston is same.

    regards,
    Christo



--