Clutch Pedal to the Floor

[scott thomas]

I experienced the same symptoms in my 200 last year. I was baffled
because the slave worked intermittantly, then failed, then worked
fine for weeks until I replaced it (after bleeding with Valvoline
synth). I think the seals may be dried, shrunken, along with bore
wear. As far as mine working fine after the flushing, I can only
speculate that the fluid conditioned the seal enough to allow it to
seal.

I decided to change it because that's a sign my slave is on its way
out.

Try bleeding with new fluid, but order a new one. CHeck for any leaks
 from the lines, too.

The Official Dream Theater Site - http://www.dreamtheater.net/
___________________________________________________________
Get your own Web-based E-mail Service at http://www.zzn.com