TB Change.. 5th gear not holding CS in place

Joshua Van Tol josh at spiny.com
Sun Jan 18 14:19:09 EST 2004


Reverse gear will most likely break at the torque level required for 
tightening the pulley bolt, so don't do that.
On Jan 17, 2004, at 3:41 PM, Dave K. wrote:

> Do you use reverse (instead of 5th) for tightening?
>
> I don't really know, I have a 2084 (and lend it out for free...)
>
> Dave K.
>
>
> ----- Original Message -----
> From: "David Thoresen" <david at epicfoto.com>
> To: <quattro at audifans.com>
> Sent: Saturday, January 17, 2004 4:03 PM
> Subject: TB Change.. 5th gear not holding CS in place
>
>
>> Am I doing something wrong here?  5th Gear is not holding the
>> Crankshaft in place so I am worried no matter how much I jump up and
>> down on the bar to tighten the bolt it wont be enough since the shaft
>> it turning...  am I doing something wrong here?  Any BTDT's (Been 
>> there
>> done that's)
>>
>> TIA!
>>
>> David
>>
>> _______________________________________________
>> quattro mailing list
>> quattro at audifans.com
>> http://www.audifans.com/mailman/listinfo/quattro
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro



More information about the quattro mailing list