Megasquirt Info

Jonathan Farrugia jfarrugi at umich.edu
Tue Jan 4 00:25:06 EST 2005


just a note that if your going to crimp your own pins you need the proper
crimping tool (open barrel crimper).  that tool will generally run you
about $60 for one that is worth having, the ultra cheap junk can be had
for about $30.  more pins and connectors can be seen here.

http://www.eagleday.com/ampconnectors.html

jonathan

On Mon, 3 Jan 2005, Dan Cordon wrote:

> While the GM pigtails are cool (in that they have the cylinder number
> stamped in to the plastic) I don't like re-using pig tails is possible.
> Also, with the I5 arrangement, you probably won't get confused which
> clip goes on which cylinder anyway.  For the custom EFI setups I do in
> my lab, I like to use the clips available from MSD. Here's a link to them:
>
> http://www.msdignition.com/fuel_10.htm#pn2400
>
> You can get these through many places, but www.summitracing.com usually
> has a pack of 8 (with pins) in stock for ~$18 + shipping.
>
> MSD also makes some decent injectors too. See them at:
>
> http://www.msdignition.com/fuel_5.htm
>
> Part # 2013 would be a 12 ohm at 50 lb/hr, but they're around $90 each.
> Chances are you'll be able to find a cheaper alternative many places.
>
> --
> Dan Cordon
> Mechanical Engineer - Engine Research Facility
> University of Idaho
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
>
>


More information about the quattro mailing list