[s-cars] Oil Pressure Gauge & Sender Install?
Mark Strangways
Strangconst at rogers.com
Wed Dec 7 08:38:16 EST 2005
The secondary IC can be retrofitted to have Oil Pressure, Oil Temp, And
Voltage.
I revamped my gauges to have oil Temp / Oil pressure / Boost pressure (using
an OEM oil pressure gauge)
For the most part it's plug and play. The engine should have the taping for
the sensor, and the wire may even be behind the dash and ready to connect.
Mark
----- Original Message -----
From: <calvinlc at earthlink.net>
To: "Chris Hemberger" <cehemberger at sbcglobal.net>; <s-car-list at audifans.com>
Sent: Wednesday, December 07, 2005 1:37 AM
Subject: RE: [s-cars] Oil Pressure Gauge & Sender Install?
> Chris,
>
> Rather than an aftermarket gauge you can get one from an S4. The S4 has
> water temp, oil press, oil temp, fuel, and a clock. The S6 has the same
> thing except that the oil pressure gauge was replaced with a
> voltmeter.....Nobody knows why they got rid of the awesome gauge package
> in
> the 200's in order to give us, of all things, an analog clock! It's even
> worse in my 2001 A6, all you have is fuel, water temp, and oil temp. If I
> had to pick gauges in order of what I wanted in the car, the first would
> be
> a tach and the next would be oil pressure. Unless I am tracking my car or
> driving wise open on the autobahn chances are that my oil temp is going to
> be fine. After ruining my very first engine rebuild because the oil pump
> pickup came loose and I didn't realize it because all I had was a idiot
> light for oil pressure I don't drive cars without oil pressure gauges.
> You
> can always just put in a mechanical gauge. They are more accurate and
> cheaper.
>
> --Calvin
>
>
> -----Original Message-----
> From: s-car-list-bounces at audifans.com
> [mailto:s-car-list-bounces at audifans.com]On Behalf Of Chris Hemberger
> Sent: Tuesday, December 06, 2005 7:54 PM
> To: s-car-list at audifans.com
> Subject: [s-cars] Oil Pressure Gauge & Sender Install?
>
>
> Howdy Folks,
>
> Relatively new to the S-Car list and have been lurking for a bit but some
> may remember me from the 200q-20v list. Yes, I have made the upgrade to an
> S6 like many of you, though I still have my 200q..
>
> I have a query regarding installation of an aftermarket oil pressure
> gauge - which the bean-counters erred in omitting. Does anybody know for
> certain what aftermarket gauges are compatible with the OEM sending unit
> as
> used on the 3B - and I believe early versions of the AAN/S4?
>
> Also, it appears the port where the 3B sender is normally installed is
> now
> 'plugged' - is this simply a threaded plug or is it something more
> permanent? I would prefer to utilize this port rather than a T-fitting in
> the pressure warning sensor port now in use.
>
> Any help/BTDT on the topic would be appreciated - I have searched the
> archives, among other sources, with no real luck or direction..
>
> Thanks in advance,
>
> Chris Hemberger
> Hebron, CT
> 95.5 S6 Avant
> 91 200q-20v Avant
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>
More information about the S-CAR-List
mailing list