[s-cars] STILL no heat!!!!

[Jerry Scott]

I had the passenger side linkage bind in addition to the servo motor 
going bad.  I had to file a flat spot on one of the linkage arms to get 
it to work properly.  As Rich suggested, expose the linkage and have 
someone cycle the temperature control to full hot and full cold.  See if 
the linkage moves proportional to the temperature settings.
Jerry

Rich Assarabowski wrote:

>Elijah:
>
>At the risk of stating the obvious, after you installed the new flap motors,
>did you make sure they operated correctly?  All the linkages installed OK?
>Could you see them move from one end to the other as you changed the heater
>settings?  As you know the temperature one is under the hood and is
>relatively easy to get at, your linkage may be slipping or binding, worth
>looking at again.  The footwell/defrost ones are buried under the dash and
>are a major PITA.
>
>Any fault codes being thrown?  Have you checked all the diagnostics that are
>available on the heater control unit?
>
>-- Rich 
> 
>
>  
>
>>Engine temp is normal. Yea, with the fan on the lowest setting but with the
>>    
>>
>heat on I get a little heat and if I turn the >temp down I get cold. As soon
>as I raise the fan speed I just get cold air. 
>  
>
>>Elijah
>>    
>>
>
>
>_______________________________________________
>S-CAR-List mailing list
>S-CAR-List at audifans.com
>http://www.audifans.com/mailman/listinfo/s-car-list
>
>
>
>  
>