[s-cars] Issue with replacing clutch on 95 S6

[Jerry Scott]

Are you sure that you used the correct clutch part number?  There are two 
and LUK has had the wrong number in their files. for the Urs4.  If the 
transmission case was hard to pull up to the engine bell housing, you may 
have the wrong one.
Jerry
----- Original Message ----- 
From: "Elvis Palombizio" <elvis.palombizio at gmail.com>
To: <s-car-list at audifans.com>
Sent: Saturday, December 06, 2008 6:17 PM
Subject: [s-cars] Issue with replacing clutch on 95 S6


> Seasons Greetings S-heads,
>       What better way to end 2008 than to replace the clutch on my 95 s6.
> The throwout bearing was going big time so I figured I'd do it 
> myself..with
> the help of a friend and his shop's lift of course!
>
>      Anyways, I use a LUK repset and had the flywheel machined.. also
> replaced the clutch slave cylinder pilot bearing and the usual items.
>
>     Last night, we put the car back together and the engine seems 
> "locked".
> Car can't start. The starter works fine, but the flywheel only turns a
> little bit now before its movement is prevented from going further. Now 
> when
> I put the flywheel on, I know the flywheel could turn on its own, but 
> before
> I take the whole thing back apart, was just wondering if anything jumps 
> out
> at any of you.
>
> Hope your holidays go well!
>
> -- 
> Elvis
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.15/1833 - Release Date: 12/5/2008 
7:08 PM