[s-cars] Part # for headlamp washer parts?

[Tom Green]

Cap, Left:   4A0 807 155 GRU  GRU refers to primer finish, so if the  
wash is paying the bill, paint to match is required.
Cap, Right 4A0 807 156 GRU

4D0 955 989A  Nozzle Left
4D0 955 990A  Nozzle Right  (The original parts #s  are superceded by  
4.2L parts)  The original numbers were 4A0 955 985/6

The best source for new parts would be San Diego Audi via this link:

http://genuineaudiparts.com/partlocator/index.cfm?siteid=214407

If you are paying for these parts, they are a little pricey to be  
buying new, considering the utility of these washers is negligible.  I  
would search the marketplace in audifans.com.  I think Brad Larson had  
some covers, and there are more cars being parted every week.  Another  
choice would be the trim below the headlights without
the hole for the nozzle and just eliminate the washer plumbing for  
both sides.

Now that I read this again, I see that I searched S6 parts but I am  
certain they are the same without retracing steps.

I would ignore Wilie's sarcasm since few of us at this point have  
paint that will be harmed in the car wash.

Tom '95 S6
          '95.5 S6 avant
Knoxville, TN

On Thursday  February 23, 2012, at 8:23 AM,  Douglas Landaeta <dlandaeta at gmail.com 
 > wrote:

> S-heads,
>
> My local car wash pulled off the body color cap AND the long spray  
> jet (drivers side). We are trying to replace but my EKTA is down at  
> the moment. Can I get a bit of help with these part numbers? Any  
> info on availability might help too.
>
> '94 UrS4 Pearl Sedan
> Dahlback tuned
>
> Doug