[s-cars] Part # for headlamp washer parts?

[Douglas Landaeta]

You rock Tom! No, I'm not paying for the car wash missing parts, but if I find them, I may stock a spare set.

Doug

Sent from my mobile

On Feb 23, 2012, at 6:31 PM, Tom Green <trgreen at comcast.net> wrote:

> Cap, Left:   4A0 807 155 GRU  GRU refers to primer finish, so if the wash is paying the bill, paint to match is required.
> Cap, Right 4A0 807 156 GRU
> 
> 4D0 955 989A  Nozzle Left
> 4D0 955 990A  Nozzle Right  (The original parts #s  are superceded by 4.2L parts)  The original numbers were 4A0 955 985/6
> 
> The best source for new parts would be San Diego Audi via this link:
> 
> http://genuineaudiparts.com/partlocator/index.cfm?siteid=214407
> 
> If you are paying for these parts, they are a little pricey to be buying new, considering the utility of these washers is negligible.  I would search the marketplace in audifans.com.  I think Brad Larson had some covers, and there are more cars being parted every week.  Another choice would be the trim below the headlights without
> the hole for the nozzle and just eliminate the washer plumbing for both sides.
> 
> Now that I read this again, I see that I searched S6 parts but I am certain they are the same without retracing steps.
> 
> I would ignore Wilie's sarcasm since few of us at this point have paint that will be harmed in the car wash.
>   
> Tom '95 S6  
>          '95.5 S6 avant
> Knoxville, TN
> 
> On Thursday  February 23, 2012, at 8:23 AM,  Douglas Landaeta <dlandaeta at gmail.com> wrote:
> 
>> S-heads,
>> 
>> My local car wash pulled off the body color cap AND the long spray jet (drivers side). We are trying to replace but my EKTA is down at the moment. Can I get a bit of help with these part numbers? Any info on availability might help too.
>> 
>> '94 UrS4 Pearl Sedan
>> Dahlback tuned
>> 
>> Doug
> 
>