[urq] part identification

[Ed Kellock]

I believe we have a "ding".  Large and brown, even the connector.   I
read through the IST docs last night looking for some mention of it.

How can I test that bad boy?

I just realized that I did not refer to Bentley last night.  That may
have helped a bit...

Ed


On Fri, 11 Feb 2005 12:57:00 -0500, Martin Pajak <martin at quattro.ca> wrote:
> Ed,
> 
> If it is rather large and brown (as well as the connector) than it is the
> Cold Start Valve thermoswitch.
> 
> Hope this helps.
> 
> Martin Pajak
> 
> http://www.quattro.ca
> 
> 1983 Audi Ur-quattro (305,000 km) In storage
> 1985 Audi Ur-quattro (203,000 km) Euro spec. import mit 3B ;o)
> 1986 Audi 4000s quattro (270,000 km) winter car
> 1971 Porsche 911T (45,000 mi) all original
> 
> 
> -----Original Message-----
> From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com]On
> Behalf Of Ed Kellock
> Sent: February 11, 2005 12:51
> To: Urq List
> Subject: [urq] part identification
> 
> '85 WX
> 
> What is the sensor at the back of the head?
> 
> It has two tabs.  The connector plug has one wire going to one contact
> and two wires going to the other.
> 
> Etka is confusing.  (possible understatement)
> 
> "early" p/n is 056 919 369P
> "later" p/n is 171 919 521F but it is stated to be 1 pin.
> 
> Does the "thermoneumatic valve" on the side of the block fail often?
> 
> Thanks,
> Ed
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
> contributions welcome!
> 
>