[urq] Clutch slave cylinder retaining pin-removal?

[Michael Hopton]

Ed,
Remove the passenger wheel and use 1/2"extensions multiple
with the right size punch. Attack through the hole for the
steering tie rods.

Cheers, Mike


-----Original Message-----
From:	urq-bounces at audifans.com on behalf of Ed Kellock
Sent:	Sun 5/8/2005 3:43 PM
To:	urq at audifans.com
Cc:	
Subject:	Re: [urq] Clutch slave cylinder retaining pin-removal?
A punch of the right-size or a cut off nail.  Even a cut off
screwdriver of the right size.  Lots of PB Blaster and lots of
patience and some improvisation..

----- Original Message ----- 
From: "Jon Archibald" <urquattro at comcast.net>
To: <urq at audifans.com>
Sent: Sunday, May 08, 2005 1:38 PM
Subject: [urq] Clutch slave cylinder retaining pin-removal?


> Any tips on how to knock this pin out with tranny "in car" for S/C
> replacement? I'm finding it exceptionally hard to simply "drive it
out" per
> Bentley. Mostly because of the tough angles involved...Any BTDT?
> TIA,
> Jon
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection:
http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ...
all contributions welcome!

_______________________________________________
Audifans urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
Have an urq question?  Check the Audifans Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
Have an urq answer? ... Please help others by adding to the KB ... all contributions welcome!