[urq] Clutch slave cylinder retaining pin-removal?

[DGraber460 at aol.com]

I have wrestled with that pin several times. Ed is right that the right size 
punch is critical. The right diameter, and short length are best. I accessed 
it from above, laying over the engine from the front, and using a large mass 
but small head sledge hammer which allowed about a 3 inch swing from the driver 
side. Your arms will feel like you went through a meat grinder, but it can be 
done. There should be a retaining spring clip going through it that must be 
removed first.
HTH

Dennis
Denver