[V8] Ignition reference sensor. Checking

[James Bass]

Yup- I *JUST* got done replacing both on mine that tested fine, but would
fail when hot.  If you have them out, replace them.  I bought a couple on
Ebay that are for a 92-99 A4 I think; MUCH cheaper than what you'll find
the V8 sensors (Same sensor, but the cheap ones have a longer wire - just
wire-tie it up out of the way...).

--james

On Sun, Jun 3, 2012 at 1:44 PM, urq <urq at pacbell.net> wrote:

> ... sorry, hit send prematurely!
>
> Yes, 1063 ohms would pass the test.  The thing is that in many cases the
> thing will fail only when it gets hot, so you may still have a bad sensor.
>
> Steve Buchholz
>
> -----Original Message-----
> From: D Morralee
> Sent: Sunday, June 03, 2012 9:16 AM
> To: audi fan
> Subject: Re: [V8] Ignition reference sensor. Checking
>
> Quick question and hoping for a quick answer ;-) I'm using my multi meter
> and I get a reading of 1063 ohms. The book manual says 1000 ohms. Is this
> still within tolerance ?
> Sent from my BlackBerry device on the Rogers Wireless Network
>
>
> _______________________________________________
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>
> You can help keep the audifans site running by shopping at
> http://audifans.com/shop/
>
>