[Vwdiesel] Rebuilt IP / Engine Won't Start

[LBaird119 at aol.com]

  Sounds like the throttle arm is put on wrong.  You really 
shouldn't pull the max fuel screw out and reset as that was 
adjusted for max fuel flow.  We tend to tweak with it a little 
but generally not on a freshly rebuilt pump.  Same goes for 
the idle screw.  It's set for the proper idle with the fuel 
screw set at the proper position.  
  I pulled the throttle arm off of mine once to inspect a sticking 
throttle even after rebuild.  Things move a little and I had basically 
the same problem only I had to hold it to full throttle to get any 
fuel at all.  Turn the shaft the other way and I'd suspect you could 
easily end up with the symptoms you're having. 
  If you didn't dink with things I'd be inclined to call the rebuilder 
and have them check things over again.  Sounds like someone 
messed up or (hopefully not) you repositioned or installed the 
throttle arm.
  What's the part number on this pump?  If you're setting to 1.15mm
 then that would imply you had a 068-130-107 (yellow dot) pump.  
If this one isn't, then it won't time to that setting.  Could set to 
.88mm, .95mm, 1.0mm, or the advanced .88 setting, which I don't 
remember.
    Loren


**************
Looking for simple solutions to your real-life 
financial challenges?  Check out WalletPop for the latest news and information, tips 
and calculators.
      (http://www.walletpop.com/?NCID=emlcntuswall00000001)