[Vwdiesel] Looking for CS cable, banjo fittings & coolant pipe

[LBaird119 at aol.com]

In a message dated 9/13/2011 7:20:39 A.M. Pacific Daylight Time,  
fudny at aol.com writes:

Hi all,  for a waste veggie oil conversion I need a few more pieces so I 
can start  plumbing it together. I need the banjo fitting for the fuel filter 
input and  the metal coolant pipe from the water pump that wraps around the 
engine to the  overflow and heater core. It is the one that bolts to the 
block not the  starter I need the bolt as well. Also my cold start cable outer 
sleeve is  broken anyone have one or a complete cable available? It is the 
one with the  CS on the knob. 




A great modification I did to my heater pipe was to put a drain  valve in 
it.  Figured out the 
right angle, took a 3/8 pipe coupling, cut it in half, ground it to fit the 
 curve of the pipe then 
marked and welded it in place.  Then, with a drill bit the size of the  
opening, drilled through 
that side of the pipe.  Screwed in a radiator valve and no more  mucking 
about to drain the 
coolant!
      Loren