4KS/GT -- Oil pressure sender

[sevans@radstone.co.uk (Steve Evans)]

Gary,

I'm afraid I can only help with the sender pin-out - hope that helps. I am assuming that it is the same beastie as I have just replaced on my '88 TQC, which was occasionally reading high. The following note and diagram was sent to me some time ago by Scott Hare <qa3@bur.dmcc.com>.

The sender has two terminals, labeled G and WK.  G goes to the dummy light and WK attaches to your gauge.  As for terminals in relation to the sender, typically the sender is a round cylinder, except for a relatively flat section with one high point.
       __
  __|   |__
(  G  WK )


The guage has a range of 0-5bar and the switch operates at 1.8 +/- .2bar.

Home that helps,

Steve
__
Steve Evans                             Radstone Technology Plc.
Principal Design Engineer               Water Lane,
                                        Towcester,
Tel: +44 (0) 1327 359444                Northants,
Fax: +44 (0) 1327 358113                NN12 6JN
Email: sevans@radstone.co.uk            ENGLAND