[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Koni parts
First question,
Anybody going to try to hit Lime Rock on friday to see the One Lappers?
Next question,
When putting Konis on a 5ktq you get extra parts. Two white plastic washers
and two steel rings. The rings are the OD of the Koni and about 1/4-3/8 thick.
There were of course no instructions or mention of what they were for.
I had the Konis put in with new wheel bearings months ago. I've been searching
for the source of a loose feel in the front end. The loose feel is not ever
since the struts were done. The old ones were beat. And the car feels better
with new ones but still has some loose feel.
I now have the super wiz bang tool to do the top strut nut and can pull the
struts out in minutes. I may as well look and see if those parts ever went in
or are needed.
So who has done this and where should the parts go. It may be obvious once I
look. And they may be in there anyway.
I'm also doing a really close look at the tie rod ends etc. The subframe
bushings are "eh". Some motion but maybe not excessive. Erics' belong there.
Thanks
Neil
CT