Re: Axel Shaft Pulling Exercises...

[PDQSHIP@aol.com]

In a message dated 96-06-18 13:11:47 EDT, you write:

<< Another fellow member also used a 6 inch puller with success, this is good
to
 know!  Now, I heard a na$ty rumour that the wheel bearings may need
replacing
 if one pulls the driveshaft out of it.  Will I need to do this?  The wheel
 bearings are only a year old, and at a hundred bucks a shot--
 
 Thanks Dave!
  >>
No not true, not unless you lower the car to the ground with the axles out of
it and try rolling said vehicle, but that would be pretty duouuuuugh, and
would require a fellow lister to come whack you with the q-list whiffle
bat.....  I have done numerous axle shafts Michael, and not one required
puller assist, and doubt you'll need to if you just did the WB's...  You can
do this, don't let Mr. Bentley intimidate you....

Scott