Allan Jones wrote:
>
> Bruce G Plante wrote:
> > I have a 87 5kSQ with 150k. I am back with several problems I need advise on.
> >
> > 1)Combination switch(turn signal) will not go out of high beam. Recommended
> > vendor quoted $150 for new. Curious if there are any out there for cheaper,
> > any other suggestions (currently using rubber band attached to the light
> > switch), and if this a job for a do it your selfer.
>
> I'm presently staring at the indicator stalk and have no idea how to
> remove it w/o breaking the SOB. Know you let me know it's $150! I was
> going to try force, but not for $150! Somebody, please help. I removed 3
> screws out of the metal contact plate after the steering wheel came off
> and do not know what to do next. Like I stated in previous post, the
> switch circles around the steering wheel spindle and I can get the
> plastic circle to move 15-20 degrees away from the plane perpendicular
> to the steering shaft, but nothing else. Is it conected to a set of
> wires that don't want to let go or is there a screw(s)?
> THANKS TO ALL IN ADVANCE,
> Allan
I finally got the indicator/wiper stalk assembly off w/o breakage, so
disregard above, thanks anyway. Now I need to know how to remove the
washer(s) holding the spring which is pushing the ignition switch
housing back. Is this dangerous/do I need a special tool a.k.a. steering
wheel puller?!? Thanks All Again!
Allan