[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
RE: Brake Sensor warning bypass trick...
Before you go to all the trouble of bypassing the brake sensor ,look at the wiring in the wheel well. The wiring approximately 6 inches above the brake pad warning sensor gets brittle and breaks. If you cut back the insulation you will most likely find 1 or both side of the brake wiring harness are cracked insulation on the wires. Just cut out the bad section and re-insulate with electrician's tape.
If you do not want to make all the effort on this repair , the use one of those blue crimping connectors that crimp wires side by side to jump the harness out. Thus completing the sensor loop, but bypassing the pad sensor itself.
Have fun
Kevin
Kbaisley@Earthlink.Net
875ks
90 90 soon