Re: Brake-Pad Wear Indicator

["Mark Pollan" <Mark.Pollan@MCI.Com>]

Bob Myers wrote in response:

>Color code doesn't matter.  Build yourself a small jumper to connect the
>two leads to the wear sensor at each wheel.  All the sensor does is connect
>the two wires.  The indicator goes off when the wire in the pad wears away
>and breaks the circuit.


Some stuff I forgot to mention:

I tried that but I must have a break someplace else.  The wire from
the brake pads is shielded and twists and turns in the engine compartment
to the point I can't find it.  Also tried cleaning the hell out of
the female receptacles to no avail so that is why I am resorting to
the Kostal.

Thanks again all for your indulgence with this minor boil on my Quattro's
butt.

Mark Pollan