RE: after-run fan switch (more)

[RELAYER@aol.com]

On my 90, the after run fan switch is located at the back of the valve cover
gasget, and DOES NOT screw into the block.  It just screws into a little wing
that comes off the back of the valve cover with 2 wires going into it.  If you
disconnect the 2 wires, the fan should NOT come on, and if you bridge the 2
wires, the fan should come on always for 10-15 minutes.

If this is what is wrong, let me know... I went and bought a new fan sensor
for my 90 before I found out that it was not the sensor, but corrosion on the
contacts that were to blame for mine not coming on.  So if you need one, i
have one I can sell you, and I will sell it for less than I paid at the Audi
dealer.

  /\        _I         Christian J. Long (& Breeze Heller - fiancee)
/    \ I_I I_I I       Orlando, Florida, USA
                       University of Central Florida Alumni 1994
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
'98 Audi A4 1.8T      Low pressure V2 rocket
'96 BMW 318ti        Will be selling for the new '99 VW Jetta IV
'90 Audi 90
Past Audis: '84 CGT, '85CGT, '87.5 CGT, '90 CQ
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
                     PIKES PEAK HERE I COME!