RE: 4kq Euro light question

[Todd Phenneger <phen9461@uidaho.edu>]

mark,
    That should be the connector for your parking lights.  An added
feature of the Euro Lights.  Is there a bulb in there.  IF so, wire it
into parking circuit.  Then make sure to relay parking circuit so you
dont fry light switch since it is taxed anyhow.    OR, if you dont want
people always saying your lights are on when you leave them on to run to
the bank teller, leave them dissconected but I think they are cool.
Some lights have it only on Driver side, some on both sides.  Not sure
about the H4 4kq lights.
    BTW, you can get sockets for the H4's at Napa and Shucks.  When you
ask for sockets for H4s you may get Blank stares but if you ask for
simple 3-prong connectors for old Sealed Beam units they will
understand.  Wire is only like 16ga on these though so you could always
just run 10ga straight to the plug terminals.  L8R

    Todd

------------------------------
I see the light plug with its three spade connectors of the huge and
hard
to find variety.  Resistance measurements should tell me how to hook it
up.  BUT, what is that plug off on the side of the rear housing?  It has

two male spade connectors (quick-connects for everyone else) in a black
plastic connector.
Mark