Re: Custom EM for 10V turbo

[c a l i b a n <caliban@sharon.net>]

	i agree.  i have to do the em someday, the 2 piece
	is too much $$$, &c &c.

On Fri, 15 Jan 1999, Mike Del Tergo wrote:

]Scott said,
]>Owning a foundry I had planed to reproduce these units, pattern cost 
]will be>around 3,000 dollars a finished product could be had for ~500.00 
]cast from>just about any material out there, stainless steel, or hi temp 
]Nickel Cast
]
]Is this a gauntlet I see before me?  Sounds as much like a challenge as 
]I ever heard.
]
]>Iron, the probelm is I don't have 3,000 bucks lying 
]
]Let's see, 10 very interested parties put up $200 deposit @ and you only 
]need 1/2 as much good faith on your end. It sounds very doable 
]especially with #'s over 10.  With some slightly more concrete 
]expectations with regard to performance enhancements over stock, and a 
]finished goods price qoute within, say, 10%, I may also find myself in 
]the I want one camp.
]Mike
]
]______________________________________________________
]Get Your Private, Free Email at http://www.hotmail.com
]


--
 rocky mullin
 http://caliban.sf.ca.us/
 two strokes are faster than four!
 this message was composed using the vi editor.
 '83 ur-q - yamaha rz350 - suzuki ts250 -  chaotic good