Re: vacuum advance replacement...

[quk@isham-research.demon.co.uk (Phil Payne)]

In message <Pine.OSF.3.95.990308141502.13637E-100000@segosf.hlo.dec.com> "G. Benedikt Rochow" writes:

> My question: Can I remove/replace the vac. adv. unit just by
> undoing those screws, or is that arm attached to something on
> the inside such that I'll have to remove-from-engine/disassemble/both
> the distributor?

The distributor was designed while Team Doorhandle were taking a
much-needed break.  Yes - amazingly - it's _that_ easy.  Main hazard
is dropping the screws - they're very, very short and fall away just
as you start to turn them.

--
 Phil Payne
 Phone: 0385 302803   Fax: 01536 723021
 (The contents of this post will _NOT_ appear in the UK Newsletter.)