Re: RE :I5 idler roller removal

[rjandrew@post.cis.smu.edu (R Justin Andrews)]

I tap them on with a mallet and wood block also after reading this!
I luckily have not tried to use the bolt :) I know it WOULD break on me
just because of my luck....
BTW, the torque on the bolt was something like 7ft/lb of torque...

HTH!
Rich Andrews
rjandrew@post.cis.smu.edu
> 
> Have you noticed everyone says this but dosen't offer an alternative. 
> I freeze them and tap them in with a hammer and wood block.  Is this
> what everyone does?
> 
> Also, remember NOT to use the 6mm bolt
> > that holds the pulley in place to pull the new pulley back into its
> recess
> > since it's guaranteed to break and ruin your day ... btdt.
> 
> _________________________________________________________
> DO YOU YAHOO!?
> Get your free @yahoo.com address at http://mail.yahoo.com
> 
>