Re: RE :I5 idler roller removal

[Wolff <quattro200@earthlink.net>]

If you get a thin (1/2" x 1" x 12") oak board you can stick it through
the front bodywork and get a somewhat angled attack on it. Works on
4kq's. Don't remember what I did on the 5kcstq, but must have been
similar.
Wolff
Richard J Lebens wrote:
> 
> Have you noticed everyone says this but dosen't offer an alternative.
> I freeze them and tap them in with a hammer and wood block.  Is this
> what everyone does?
> 
> Also, remember NOT to use the 6mm bolt
> > that holds the pulley in place to pull the new pulley back into its
> recess
> > since it's guaranteed to break and ruin your day ... btdt.
> 
> _________________________________________________________
> DO YOU YAHOO!?
> Get your free @yahoo.com address at http://mail.yahoo.com