Re: Euro Light Harness

["Dave Puterbaugh" <deputer@email.msn.com>]

The part numbers areas follows:

Grommet  (rubber cover) - 447941189 - $3.08 ea. - need two

 Connector ( holds spade connectors ) - 447972957 - $1.65 - need two

Connector ( metal spade ) - n0178514 - $.90 - need eight

The prices are all from Linda at Carlsen last year.  The most important
thing to get is a professional wire crimper.  I paid about $40 for one that
crimps the connector to the wire, and also crimps to the wire insulation.  i
believe in quality tools, but was reluctant to buy this tool.  One use of it
and I am sold.  Makes the wiring a total pro job!  Thanks Ned Ritchie for
the tip about the tool.  I have used stock wattage bulbs, and my reminder
does not show bulb problems.  I hope I am not pressing my luck.

Hope this helps.

Dave Puterbaugh
1991 200 tq, euros without a harness, IA stage III chip, 17" BBS/w Dunlop
sport 8000
----- Original Message -----
From: Wolff <quattro200@earthlink.net>
To: <quattro@coimbra.ans.net>
Sent: Monday, March 22, 1999 7:28 AM
Subject: Euro Light Harness


> Well, I have given up on Todd Candy to make me a wiring harness for my
> Euros for my '91 200 tq. He keeps promising it, but how many months has
> it been?
>
> So if someone knows the part #'s for the 4 prong sockets, boots,
> connectors etc. I would appreciate it. Also I need to know where to put
> the resistor to defeat the lamp check (and what value the resistor is).
> I should have paid attention to all of this earlier, but I thought I
> would have pre-made harnesses from Todd.
> Thanks,
> Wolff
>