RE: removing a 5k windshield...help!

["Lewis, Gary M" <Gary.Lewis@West.Boeing.com>]

Cobram said;

> "Lewis, Gary M" <Gary.Lewis@West.Boeing.com> writes:
> 
> >This isn't a contradiction, but a question.  My 88 5kcstq is leaking 
> >water onto the floor of the car.  I noticed a rubber seal bulging out 
> >between the windshield and the chrome strip, on the same side 
> 
> There may be a some rubber molding, but it doesn't hold in the windshield
> like the old VW, Mercedes Benz etc. windshields were held in, as the
> original poster was alluding to.  The 5K windshield is held in and sealed
> with an adhesive.  I'm going from memory here,  I will check the Bentley
> (don't have it where I'm at now) but I think they go into good detail on
> the winshield section.  
> 
> Is the water leaking on the  passenger side footwell area?  If it is, it
> may not be the windshield.  
> 
Why yes it is...  The A pillar moulding is soaked with water at the bottom.
ANY comments are VERY appreciated...
And thanks for replying.

Gary Lewis 
88 5kcstq 1.8 bar 110km Pearl w/Fuchs, K24 turbo, 2-piece EM
86 5kcstqw Sapphire and Platinum, stock 
Mergers, Acquisitions, Public Offerings
(818) 384-7600