Shogun pump wiring

["Daniel Hussey" <dan_hussey@email.msn.com>]

OK, Have the pump now and looking in the engine bay...

I have the relay in front of me and just want to check with you on what goes
where!

So. There are TWO power wires from what I can tell (why two???)...  One
brown ground.

Now, I figure I run power from wiring harness (went to orig pump...which one
I don't know, but one of the red ones) to the #85 pin.  Then from the #86
pin to the positive terminal of the new pump.  Correct me if I'm wrong.

Now left to the ground.

Pin #87 to pump ground wire, and #30 to negative (brown) wire from original
wiring harness (for original pump).  Is this correct?

Do I put the fuse (10A) from the positive lead to the relay, or from the pos
lead running from the realy to the pump???

I may have this totally ass backwards, but this doesn't look that complex.
Once I get what goes to what pin, it should be an easy install.

BTW, I've decided to mount my pump vertially in the engine bay.  The guide
says you can do this and it looks like it will line up the hoses perfectly.
Any help or advice appreciated!

Later,
Dan