re A/C recirc question

[rochow@pixelmagic.com]

>>only works with the A/C turned on. This annoys me. I would like to
>>rewire the switch for Recirc so that I can turn it on and have it
>>activate the recirc flap independent of the A/C. The concept holds no
>>
>>I figure there must be one wire coming off the A/C switch that powers
>>the switch for Recirc, if I can figure out which wire that is, I could
>>cut it from the A/C switch and run switched ignition power to it, so
>>that I could activate it any time the ignition is on.
********
>a pain to rewire it.  You have to remove the center console parts to get to
>the back of the switches.  You also have to pick up +12 somewhere there.  

IF it's indeed all electrical, and the A/C switch switches 12V to a wire going 
to the recirc. switch, shouldn't 12V be freely available where they go *into*
the A/C switch? Even if those 12V are switched by something else, too
(e.g. ignition), it doesn't matter, as the A/C switch is all you're trying to
bridge.
So it should just be a matter of moving 1 wire from 1 pin to another.

?

-gbr