RE: Rear Diff Oil Seal Replacement Questions

["Levis-Fithian, Jeff E" <LevisJE@LOUISVILLE.STORTEK.COM>]

It sure would be fun to strip those bolts.  I know we had this thread a
while ago, but where could one purchase an infamous "triple square" bit?
-Jeff
Oozing 95 A6Q

		-----Original Message-----
		From:	Todd Young [mailto:tyoung@wamnet.com]
		Sent:	Friday, September 10, 1999 6:33 AM
		To:	Levis-Fithian, Jeff E
		Subject:	Re: Rear Diff Oil Seal Replacement Questions

		"Levis-Fithian, Jeff E" wrote:

		> 2.      The 6 bolts that hold the drive axle to the
flanged shaft look like
		> torx bolts.  ETKA says they are BM10x48x26 size w/ polygon
head.  What size
		> torx socket do I need to get for these?

		I don't think they are Torx, I'm willing to bet they are
"triple square". Use a
		Torx bit and you will probably round them out.

		--
		-----------------------------------------------------------
		Quote for the day:
		Of course I don't look busy, I did it right the first time.
		-----------------------------------------------------------
		Todd Young              WAM!NET Inc.
		tyoung@wamnet.com       655 Lone Oak Drive, Bldg#A
		651-256-5051            Eagan, MN 55121
		800-585-1133 ext.5051   http://www.wamnet.com/
		'93 Audi 90S(|___\====OOOO====/___|)