| Filter without fuel preheating:- Slacken off breather screw (arrow A)
- Slacken off drain plug (arrow B) and drain off approximately 100cm3
- Retighten drain plug and breather screw
| Filter with fuel preheating:- Remove clip 5 and take regulating valve off with fuel pipes connected (not applicable to engine code 3D)
On this engine slacken off breather screw 2 as well (see figure 02-489) - Drain off approximately 100cm3 at the water drain plug (see figure 20-052)
- Install regulating valve, refit clip and tighten drain plug (also breather screw on 3D engine)After installing the filter:(With and without fuel preheating)
- Check fuel system for leaks
- After the engine has been accelerated a few times, fuel should flow through the transparent hose free of bubbles at idling speed
|
|