hot spot update

["Lino M. Valadas" <valadasl@osha.igs.net>]

Hello again

I took my seat apart again.  The soldering job was perfect. The problem was
the wiring going again, this time about one inch from where I'd fix it. 
When it goes it burns up, thus the hot spot.  It burnt a nice hole in  the
foam,  pad, and back of upholstery material.  Lucky it did not go through
the upholstery.  I  cut the whole mess off including the previous splice
and re-solder it.  I have tested and its working fine so far.

Thank you

Lino