Re: UrQ cruise control

[Bryan Gunn <bgunn@voicetek.com>]

Hi Andrew,
 
> In the Bentley manual the 1st test for the cruise control is
> the connect a jumper between terminals 1 and 3 and depress
> the brake pedal. The note says that the test light should go
> on. My 1983 UrQ with non functioning cruise has the light go
> on for a miniscule travel of the brake pedal and then the light
> goes out. If I look at the wiring diagram this makes sense as
> the cruise switches on the clutch and the brake interrupt the
> power supplied from the brake system to the cruise control
> module. Is the manual wrong? Or is my system wrong. All
> the other tests in the Bentley are fine. I have replaced the
> brain twice and no luck. Anyone have any ideas.

Cruise died in my car. It was the switch in the stalk.

Later,
-- 
******************************************************************************
*            Bryan Gunn                  Email: bgunn@voicetek.com           * 
*            Voicetek Corporation          Tel: 508.250.7998                 *
*            19 Alpha Road                 Fax: 508.250.9378                 *
*            Chelmsford, MA  01824                                           *
******************************************************************************