Re: A/C programmer motor assembly

[audistuff@juno.com (Paul R Anderson)]

I just replaced the motor on my 875kq with the one out of my parts
85 5k.  I couldn't find the parts to check for certain but I believe the
motor travel is determined by where the cable ends up and not on
the motor itself.  Therefore, as soon as you hook it up and run it
through its cycle, it will be just fine.  Someone please correct
me if I'm wrong.


Paul Anderson, Cheyenne, WY  Private email:AndersonPaul@juno.com


On Tue, 28 Oct 1997 23:05:03 -0500 Brendan <bman@swva.net> writes:
>No!  Not *another* a/c post!  ;)
>
>After pulling apart the little black box, I discovered the problem 
>with my
>programmer was the motor and not the solenoids.  I grabbed a used box 
>from
>a boneyard, and pulled the motor open to make sure it didn't suffer 
>the
>same malady.  Unfortunately it didn't occur to me to mark it in any 
>way
>before pulling it apart, so I believe the plastic arm mounted to the 
>motor,
>the one that moves the cable, is not "aimed" right.  Does anyone have 
>a
>procedure for this?
>
>TIA,
>Brendan
>