Re: Bodywork

[quk@isham-research.demon.co.uk (Phil Payne)]

In message <36FAE498.C41183C9@cisco.com> Scott Fisher writes:

> > Yeah, but how do you properly -- and permanently -- fill a gouge?
>
> You don't.  You flatten it first, with the dolly held *behind* the
> panel, and each tap of the hammer brings the (heavier) dolly forward,
> smoothing out the gouge.  Slow and steady (and wear ear protection).
>
> Then, assuming that this gouge is a place where the metal has been
> stretched, ...

Ur-quattro rear valance is plastic.

--
 Phil Payne
 Phone: 0385 302803   Fax: 01536 723021
 (The contents of this post will _NOT_ appear in the UK Newsletter.)