Re: 88 80q alignment of frame?

[Robert A Strain <rstrain@wam.umd.edu>]

Oh dear....

On Wed, 20 Jan 1999, Obin Olson wrote:

> Guys,
> I have an 88 80q and I think it was in a fender-bender once 
> in it's life, is there a way I can measure the frame in the front
> to see if it's out of alignment ??
> Also I just replaced the front and rear lower control arm bushings
> but they STILL MOVE BACK AND FORTH AS I DRIVE OVER BUMPS OR TURN AT SLOW 
> SPEED!! when I took the lower arms out I had to beat them on
> the floor to get the bushings back in....I know this was not good 
> because I bent the arms a little... I did but a small jack in between 
> the arms to push them out again.... is this my problem???
> Also, Also, how do I know if my engine mounts are bad?
> 
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>